Save single image

This block is used to save 2D images.

Name of the block for display in the overview.
Selection of the test station for which this module is to save data. If the option "All" is selected, the data will be generated for all stations.
Name of the display record to be saved.
If this save condition is met, then the data set is saved. The configuration is done via the integrated condition editor.

File type:
- TIFF: Display record (single image) without overlays
- BMP: Display record (single image) without overlays
- JPEG: Display record (single image) without overlays
- IDB: Display record (single image) without overlays
- OVERLAY (JPEG): Display record (single image) with overlays
- PDF: Display record (single image) with overlays
- HTML: Display record (single image) with overlays and inspection results
- PNG: Display record (single image) without overlays
Compression of the image for JPEG and OVERLAY
  Original image: The image is saved in the available resolution Reduce image: The image is reduced to the configured resolution
New image width for "Reduce image".
New image height for "Reduce image".
Configuration of the base folder. The configuration is done via the integrated configurator.
Configuration of the base folder. The configuration is done via the integrated configurator.
  This option is available only for HTML!

Append data: If the file name is the same, the new data will be appended to the existing file
Overwrite file: If the file name is the same, the existing file will be overwritten
By age of data Deletes all files from the set age.
Maximum number of files Deletes all data if there is more than the set number in the folder.
Minimum free memory Deletes all files by age when the disk space falls below the set value.

Please note the further information on cleanup!

The test mode is used to test the storage condition or the paths and file names. IMPORTANT: There must be a test result with valid data for the test to be performed.